In Belleville, Quinte West and the southern Hastings County townships, the septic permit comes from the municipality’s building department, not from Quinte Conservation and not from the health unit. Quinte Conservation issues a separate permit when a lot sits inside its regulated area, and that one has to be in hand before the municipality will issue the building permit.
So a lot on the Moira River or the Bay of Quinte shoreline can need two approvals for one septic job. A common holdup is applying for one without knowing about the other.
Below: who does what in Belleville, Quinte West and the townships, the application, fees, inspections and records. For the province-wide rules behind all of it, see our guide to septic permit requirements in Ontario.
Who Issues the Permit, Municipality by Municipality
Every septic permit in Ontario is issued under Part 8 of the Building Code. The current Code is the 2024 Ontario Building Code, O. Reg. 163/24, in force since 1 January 2025. The rules are the same across the province, but who administers them is decided locally. In some parts of Ontario a health unit or a conservation authority runs the program. Around Belleville, the municipalities we checked run it themselves.
| Municipality | Who issues the septic permit | What the municipality publishes |
|---|---|---|
| City of Belleville | City building section | Lists installing a septic system (except a Class 1) as work that needs a building permit, with separate sewage system fees |
| City of Quinte West | City building department | New, repair, replacement or alteration of on-site sewage systems is subject to permits and inspection by the City’s building officials |
| Stirling-Rawdon, Deseronto, Madoc Township, Marmora and Lake, Tweed, Tyendinaga | Each township, with inspections handled by a shared Building Inspection Services Board (BISB) | Stirling-Rawdon and Madoc Township take applications online through Cloudpermit |
| Centre Hastings and the northern Hastings townships | Ask the township | We did not verify these for this post |
Two practical notes. In Madoc Township, the online form asks you to pick a category, and the township’s instructions say a new septic goes under Sewage System, not Residential Building. For any township not listed, call the office and ask who reviews Part 8 sewage system applications for your address.
Where Quinte Conservation Fits In
Quinte Conservation covers the drainage basins of the Moira, Napanee and Salmon rivers plus all of Prince Edward County. It regulates work near wetlands, watercourses, steep slopes and lake shorelines. It does not issue septic permits, but its own permit schedule lists new or replacement sewage systems among its Standard Applications, at $485 on its permit application page.
The order matters. Quinte Conservation’s guidance is that its permit must be obtained before the municipality issues a building permit, because the Conservation Authorities Act counts as applicable law under the Building Code. You can apply to both at the same time, but the building permit waits for the conservation permit. Stirling-Rawdon’s permits page lists Quinte Conservation among the approvals a homeowner is responsible for getting before applying for a building permit.
How to tell whether this applies to you:
- Check your address on Quinte Conservation’s Property Regulation Map.
- If you are close to the edge of a regulated area, book a call or a site visit with their staff before the designer finalizes the layout.
- Not all of the Belleville area drains to the Moira or Napanee. Parts of the region fall under other conservation authorities, so confirm which one covers your lot.
One change coming: Quinte Conservation, Kawartha Conservation, Ganaraska, Otonabee, Crowe Valley, Lower Trent and Cataraqui are preparing to merge into the Eastern Lake Ontario Regional Conservation Authority, effective 1 February 2027. Quinte Conservation says its programs continue through the transition, so expect new names on the forms rather than a different process. Our post on Kawartha Conservation and septic permits shows how conservation review plays out on a septic job further west.
What Goes Into an Application
The forms change from town to town, but every application needs the same few things.
A design from a qualified designer
A septic design is prepared by a sewage system designer registered with a BCIN in the sewage systems category, or by the owner for their own house where the Code allows it. Belleville’s application forms ask whoever prepared the septic design to take responsibility for it on the Schedule 2 form, and the City’s permit clerk checks a designer’s BCIN against the province’s QuARTS public registry. Our post on who does what between the designer, installer and engineer explains why the design and the build are separate jobs.
Quinte West publishes its own set: a Sewage System Design Package, Schedule 1 (designer information), Schedule 2 (installer information) and a Sewage System Review Form, with the application itself filed through the City’s e-permit system.
Soil information
The design rests on the soil. Expect a perc test and, on most sites, a soil profile or deep test pit to find bedrock and the water table. Designers do not test frozen ground, so soil work here is a late-spring-to-fall job. If you are planning a spring install, book the designer in the fall.
Clearances
The design shows the tank, the leaching bed and the distances to everything around them. For wells, a leaching bed needs 15 metres (50 feet) from a drilled well with a watertight casing at least 6 metres deep, and 30 metres (100 feet) from a dug well or any other well. The tank itself needs 15 metres from any well. Municipalities and conservation authorities can ask for more.
The conservation permit, if it applies
If your lot is in a regulated area, the conservation authority’s permit goes in alongside or ahead of the building application, for the reason above.
What a Septic Permit Costs in Belleville
The City of Belleville publishes its sewage system permit fees on its building permit fees page:
| Belleville sewage system permit | Fee |
|---|---|
| Class 1 (new) | No fee |
| Class 2, 3, 4 or 5 (new) | $640 |
| Repair, alteration or addition | $150 |
For Quinte West and the townships, ask the building department for the current fee schedule. We did not find those fees published in a form we could verify for this post.
The permit is the small line. The soft costs before any digging are larger:
| Before digging | Typical range |
|---|---|
| Licensed sewage system designer | $1,500 to $3,500 |
| Perc test | $500 to $1,500 |
| Soil profile or deep test pit | $500 to $1,000 |
| Design and site evaluation together | $2,000 to $6,000 |
Add the municipal permit, and the conservation permit if you need one. A full septic system replacement runs $15,000 to $35,000 in Ontario, with most jobs landing between $15,000 and $30,000. Our septic system replacement cost guide breaks that down by system type. Outside the City of Kawartha Lakes, including the Belleville area, we quote every job up front after a site visit.
Inspections: When to Call and What Gets Checked
A septic permit is permission to build plus a promise to let the inspector see the work before it is buried.
Quinte West spells it out on its on-site sewage page. The permit holder has to give the building department two business days’ notice at each stage, as the Building Code requires. The two required inspections are the distribution piping before backfill, and the final inspection once the pipe is covered and vegetation is in place. On a new house, the septic system has to be operational and inspected before an occupancy permit is issued.
Belleville says an inspection takes place within two business days of the request, and you book it with the inspector named on your permit.
In the BISB townships, inspections go through the shared board, and the township’s permits page has the booking contact.
The rule everywhere: do not backfill the bed before the inspector has seen it. Covering uninspected pipe is the fastest way to pay for the excavation twice.
Repairs, Alterations and Additions
Not every repair needs a permit, but a surprising number do. Replacing a tank, rebuilding or moving a bed, or adding treatment all count as alterations. Our decision guide to septic repair and modification permits sorts the common jobs into permit and no-permit.
Belleville prices repairs, alterations and additions as their own permit category, which tells you the City expects to see them. The City also warns that a house addition can drag the septic system into the review: extra bedrooms, more floor area or added plumbing fixtures can mean the existing system has to be evaluated for capacity, and upgraded if it falls short. If you are planning a bedroom addition on a septic lot, get the system looked at before the architect finishes the drawings.
Finding Records for an Existing System
If you are buying a rural property near Belleville, ask for the septic file early.
Quinte West runs a sewage system search request. You give the property details, prior owners and the approximate year of construction if you know them, and pay a small non-refundable fee. The City searches on a best-efforts basis and does not guarantee a record will turn up.
In Belleville and the townships, ask the building department what they hold and how to request it. Older systems in particular may predate the current records, so a missing file is a question to ask the municipality about, not proof of anything by itself. A septic inspection fills the gap either way: it tells you what is in the ground now, whatever the paperwork says.
How Long It Takes
Timelines in the Belleville area follow the same pattern as the rest of Ontario:
- Permit review: 2 to 6 weeks in most Ontario municipalities for a straightforward application.
- Conservation authority involvement: add about 4 weeks to the design-to-permit stretch.
- Replacement, first call to finished system: 4 to 8 weeks.
- Excavation on site: 2 to 5 days for most residential systems.
The slow parts are usually the designer’s calendar in peak season and the soil testing window. A failing system found in November often means a plan over winter and a build in spring.
Frequently Asked Questions
Who issues septic permits in Belleville?
The City of Belleville’s building section issues them. Installing any septic system other than a Class 1 needs a permit, and the City publishes separate fees for new systems and for repairs, alterations and additions. If your lot is in a Quinte Conservation regulated area, you also need Quinte Conservation’s permit before the City will issue yours.
Does Quinte Conservation issue septic permits?
No. Quinte Conservation issues permits for work in its regulated areas near wetlands, watercourses, steep slopes and shorelines, and a new or replacement sewage system in those areas needs one. The septic permit itself comes from the municipality, and the conservation permit has to be obtained first.
How much is a septic permit in Belleville?
The City of Belleville lists $640 for a new Class 2, 3, 4 or 5 sewage system, $150 for a repair, alteration or addition, and no fee for a new Class 1. Design and soil testing cost more than the permit, typically $2,000 to $6,000 together. Check the City’s fee page before you apply in case the schedule has changed.
Who issues septic permits in the Hastings County townships?
In the townships we checked, the municipality does. Stirling-Rawdon, Deseronto, Madoc Township, Marmora and Lake, Tweed and Tyendinaga share a Building Inspection Services Board for inspections, and Stirling-Rawdon and Madoc Township take applications online. For any other township, call the office and ask who reviews Part 8 sewage system applications for your address.
Can I install my own septic system near Belleville?
The Code allows an owner to design a system for their own house, and Belleville’s forms account for a homeowner-prepared design. You still need the permit, the inspections and a design that meets Part 8. Most owners hire a registered designer and an installer because the soil work, sizing and clearances are where applications get sent back.
Planning Septic Work Near Belleville?
Our service area runs east to Belleville. We pump and inspect systems there, and on installs and replacements the design is stamped by a licensed designer while we handle the excavation, the installation and booking the inspections. Every job outside the City of Kawartha Lakes is quoted up front after a site visit.
Call (705) 702-5526 or book a visit. The full install sequence is on our septic system installation and replacement page, and we call back within 24 hours during business hours.